English
Mon compte Créer un compte
English
EVO-START Wirecolor

Votre panier

Votre panier est vide.

Votre panier est vide.

Continuer le magasinage

TOTAL ESTIMÉ :

Commander

RECHERCHE RAPIDE DE VÉHICULE

RECHERCHE VÉHICULE

Utilisateur

Alexandre Messier

À rejoins en date due:

May. 21, 2010

Points

2580

Commentaire(s)

3

Questions votée(s)

9

Réponses votée(s)

15

Votes positifs

3

Votes contre

21

Votes reçus

0

Votes négatifs reçus

0

Activité récente

Questions demandée(s)

0

Question(s) répondue(s)

17

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question
ACTIVITÉ RÉCENTE QUESTION(S) DEMANDÉE(S)" QUESTION(S) RÉPONDU(S)" QUESTION(S) COMMENTÉE(S)"

27/09/2016

 Ford Philip Emke (130Pts.)

0

Activation code not working

I used my activation code to check out how your web page worked...now I am ready to install everything and now it says that the activation code doesn't work. it is for the vehicle i first looked up.......just want to do the install now is there a way to acess the vehicle or am I hooped now I did not realize that the activation code was a one time thing, I thought it perminently unlocked that perticular vehicle. thank you
Connectez-vous pour répondre Voir 1 réponse(s)

09/12/2014

 Toyota Micheal Unger (2680Pts.)

0

Check Engine Light 2010 4runner

Hello, installed CT-3471TW Prostart remote starter with D2D EVO-ALL into 2010 Toyota 4Runner. Unit worked great, sent home with customer, Vehicle has check engine light that night, code P0705 "transmission range sensor A circuit". Used wiring guide provided from "wirecolor" and guide #8971 for Evo-all. If I clear fault, drive vehicle around- is fine. start with remote starter, key takeover, put in reverse, CEL and Traction control light illuminate on dash. Checked wiring connections at ignition switch, IGN 1- black pin6, Ign 2 purple pin 4, starter 1 red pin8, starter 2 black pin2. For the extra starter wire i used a standard relay, pin 85 ground, pin 86 to starter 1, pin 30 to +12v. pin 87 to starter 2. Any ideas? Thanks, Mike.
Connectez-vous pour répondre Voir 3 réponse(s)

23/12/2013

 Kia Robert Nelson (130Pts.)

0

When will a All in One Module be available for a 2012 Kia Optima Push Button Start ?

When will a All in One Module be available for a 2012 Kia Optima Push Button Start to enable remote start without adding a remote start system? Can a smart start Module also be plued into your ALL In One Modules? I would also like to use my Iphone to control remote start. If you do not have a module the includes remote start please tell me which module to use and which remote start system with smart start to but to use with the module for my vehicle. Thank You Please also remove all of my questions that are posted they have my information included with them
Connectez-vous pour répondre Voir 1 réponse(s)

22/12/2013

 Ford Carlo Ferrara2 (130Pts.)

0

EVO-ALL Wiring instructions for 2013 F-150

I have an EVO-ALL for my 2013 Ford F-150. I am very handy when doing my automotive work and I have found the wiring schematics to be utterly infuriating. I will be using this as a standalone model for remote-start applcation. For this model, what wires need to be hooked up to the 20-pin connector and where? I have found little to no information anywhere regarding this vehicle that doesn't also pertain to 5 or so other Ford models.
Connectez-vous pour répondre Voir 1 réponse(s)

22/12/2013

 Chevrolet Kyle Zelazny (130Pts.)

0

Not programming with 2011 equinox

I tried programming the key numerous times. After the second time of turning the key off, the blue led stays on. I can start my car using the key, but the remote start feature does not work. What is wrong?
Connectez-vous pour répondre Voir 1 réponse(s)

22/12/2013

 Ford Utilisateur Fortin

0

I see many UPCs for Flashlink

Is this UPC updatable 048097312163, or is it one to be returned?
Connectez-vous pour répondre Voir 1 réponse(s)

22/12/2013

 Chevrolet Xavier POUVIOT (130Pts.)

0

Chevrolet cruze Diesel boite manuel

Bonjour je possede une chevrolet cruze diesel en boite manuel de 2009 (elles etaient d
Connectez-vous pour répondre Voir 1 réponse(s)

22/12/2013

 Nissan Anthony Laurentino (240Pts.)

0

2013 Nissan Murano Evo-All Standalone sometimes no key and transponder picture in display when remote starting.

Hello, I have a 2013 Nissan Murano with the evo-all acting as a standalone remote starter. When attempting to remote start, sometimes it works, and sometimes it does not. The times it does not, on the vehicles display it comes up as "no key" and then switches to an image of no key in the transponder port. Does this have anything to do with installing a diode? I see on the PDF install guide under parts listed is one diode, but it is not shown anywhere in the schematic on where to install said diode.
Connectez-vous pour répondre Voir 2 réponse(s)

22/12/2013

 Mazda Dave Neraasen (130Pts.)

0

fortin evo-all and mazda 3

Hi there, i'm wanting to install remote start in the little lady's mazda 3 but and a little confused with the installation guide(wiring pics). do i have to cut any wires and splice ? is the a specific harness required ? is there a step by step install guide anywhere? is it plug and play ?
Connectez-vous pour répondre Voir 1 réponse(s)

21/12/2013

 Chevrolet Steven Waite (130Pts.)

0

Is there special wiring needed to have Passlock II bypassed for starting with a key. 98 Blazer

Is there special wiring needed to have Passlock II bypassed for starting with a key. Will the wirning in the directrions also bypass for key starts. 98 Blazer
Connectez-vous pour répondre Voir 1 réponse(s)

21/12/2013

 Ford Mobile Edge (270Pts.)

0

EVO-Ford Applications

On the EVO-Ford, can it be used on other 40 bit cars with the same ignition plug and Can BUS, such as a 2006 Explorer, or 2006 Fusion, 2008 Escape? I see it works on a 2008 Taurus. Just wondering if it will work on others that old.
Connectez-vous pour répondre Voir 1 réponse(s)

21/12/2013

 Mazda Chris Gates (260Pts.)

1

Is there a solution for 2013 Mazda 5 push to start

Just checking to see if there is a solution for 2013 mazda 5 push to start
Connectez-vous pour répondre Voir 2 réponse(s)

20/12/2013

 Mazda Taylor Duzan (390Pts.)

0

How do i take the dash apart around the push-start button on 2011 mazda 6?

the push start button is below the radio and i cant seem to find a way to get to the back of the button to hook up the wires. how do i get to the plug on the back of the push start button??
Connectez-vous pour répondre Voir 1 réponse(s)

20/12/2013

 Toyota Sean Richardson (480Pts.)

0

Should I exchange my unit?

I have been on here a lot! I just removed each of my connections and reconnected them. I volt-tested my ignition wires to be correct and tried my connections on both. My unit still only turns the vehicle on to accessory (or on) but not ON as in with the Ready light on and motor running. When I push the lock button 3 times, the doors unlock, the vehicle switches on to accessory and then the vehicle locks. The Evo units light up red first then the yellow light comes on. My vehicle is a 2008 Toyota Highlander Hybrid Limited, fully loaded (if that makes any difference). The service number on my Evo unit is 001A06 248524. The retailer I purchased from has offered to exchange it but that requires me mailing it back to them and waiting for a new one which will take approximately a month (Ottawa to Arizona + processing times). I want to know if it is a possiblity my unit is defective of what else I can possibly do to make this work. PLEASE help me to get this working! Thanks.
Connectez-vous pour répondre Voir 2 réponse(s)

14/12/2013

 Nissan nascar (230Pts.)

1

2008 nissan altama pts sometime says no key when you try to remote start

Don't no really what's going on I have done a lot of Nissan Altima pts and Infiniti g35 with wire guide 5a when I remote start sometimes it will not work one the first try it will say on dash no key ,then retry and start I believe it may be a software issue this week I have installed 6 remote starters on these type of cars and today have used a different bypass because it seems intermittent when using an evo all would like to no if I should down grade software thanks
Connectez-vous pour répondre Voir 2 réponse(s)

08/12/2013

 Pontiac maxcat (190Pts.)

1

Just wanted to confirm the evo-all will work on the passlock or passkey of a 2005 pontiac pursuit.

The info on the website makes it look like the evo-all does not bypass the passlock or passkey on a 2005 pontiac pursuit, instead it looks like the passlock sl2 is to be used. can you confirm that the evo-all will or will not bypass the passlock or passkey on this particular vehicle. Thank you in advance for your time
Connectez-vous pour répondre Voir 1 réponse(s)

07/12/2013

 Volvo Ken White (190Pts.)

0

Unable to program EVO-ALL to Volvo S60

Installed EVO-ALL into 2005 Volvo S60, begin programming - blue LED on, once i put key in ignition, Light goes out. turn the key to acc, and light stays out. light comes back on when key is taken out of ignition.
Connectez-vous pour répondre Voir 1 réponse(s)

06/12/2013

 Nissan Mike Molchan (190Pts.)

1

2009 Nissan Murano Remote Start using an EVO-ALL

Parts required list a diode, but the schematics don't show where?
Connectez-vous pour répondre Voir 1 réponse(s)

30/11/2013

 Dodge Daniel Nuber (210Pts.)

0

2006 ram srt 10. factory alarm interference

sometimes works well . most of the time it shuts down . always get door open response when dome is off. evo all viper alarm thar 5. seems to work better if drivers door is open. Daniel 4257914222
Connectez-vous pour répondre Voir 1 réponse(s)

No results

picto contact

Vous cherchez nos meilleurs participants ?

Voir les utilisateurs
picto contact

Vous n'avez pas trouvé ce que vous cherchiez ?

Posez une question

Support Technique

Recherchez parmi nos produits les plus populaires et les sujets d'installation disponibles dans notre section Questions et réponses.

En savoir plus
Téléchargez notre application de guides de dépannage étape par étape disponible pour iOS et Android ou parcourez notre version de bureau.

En savoir plus
Accédez à la plus grande base de données de schémas de câblage et de photos en ligne de l'industrie. Un jeton gratuit est fourni dans chaque boîte EVO-SERIES.

En savoir plus
Vous n'avez pas trouvé l'information que vous cherchiez ? Posez-nous une question en remplissant le formulaire de demande de support technique. Un spécialiste produit vous répondra sous peu.

En savoir plus
Des solutions de contrôle à distance et de connectivité à la fine pointe de la technologie au soutien technique haut de gamme, découvrez pourquoi vous devriez choisir les produits Fortin.

En savoir plus

Ce site Web utilise des cookies pour vous garantir la meilleure expérience utilisateur. En poursuivant votre navigation sur notre site, vous acceptez notre utilisation des cookies. En savoir plus Continuer